RP-400

These stockings are designed for joining cables or ropes with the same diameter and without a lot of twist. This way it is, for example, possible to change crane ropes in one run or to include two cable lengths at once. In case of increased torsion of the cables etc. we recommend using single stockings together with respective whirl shackles to compensate for the twist. This mesh of galvanized steel braids is woven with two strands, open on both ends and has no eyelets.

Cable stocking RP-400
For cables and ropes
with ø from – to
Permissible tension load in kN / tons
approx.
Thimble size
for bolt ø
approx. mm
Part number (for ordering)
Please indicate required length/s (e.g. RP-410-1500) for stocking length 1500
06 - 08 mm
3,60 / 0,37
open on both sides
RP - 406 - + length
08 - 10 mm
3,60 / 0,37
open on both sides
RP - 408 - + length
10 - 15 mm
5,12 / 0 ,52
open on both sides
RP - 410 - + length
15 - 20 mm
6,93 / 0,71
open on both sides
RP - 415 - + length
20 - 30 mm
8,67 / 0,88
open on both sides
RP - 420 - + length
30 - 40 mm
10,40 / 1,06
open on both sides
RP - 430 - + length
40 - 50 mm
21,36 / 2,18
open on both sides
RP - 440 - + length
50 - 60 mm
21,36 / 2,18
open on both sides
RP - 450 - + length
60 - 80 mm
28,48 / 2,90
open on both sides
RP - 460 - + length
80 - 100 mm
45,60 / 4,65
open on both sides
RP - 480 - + length
100 - 120 mm
50,67 / 5,17
open on both sides
RP - 4100 - + length

Available in standard total lengths 1500 mm, 2000 mm and 3000 mm. Other lengths upon request!

Also available in the following design:

  • Stainless steel (stainless steel braiding)
  • Stainless steel reinforced (three-layer design for higher tensile strength)
  • Strained Bowden cable
  • Plastic coated strands

Greater loads and higher tensile forces
and special designs on request.
Produceable immediately.

We strictly sell goods under our terms and conditions. Mistakes as well as misprints reserved.